Solar module machine Automatic solar module lamina

Solar module machineEquipment survey:Laminating Area :3600*2200 (3600*1800,3400*2200,3200mm*1800mm)Power supply:380V,three phase Control mode:touch-screen/panel operateMax.vacuum:10Pa Air pressure:0.02Mpa---0.1MpaTemperature uniformity :±1°C,multi-point controlCompressed air pressure:0.5---0.8MpaCompressed air flux:0.22-0.5 m³/minMax consumption: 60 KW Working consumption: 15 KW Equipment characteristic:1 In and out module :the laminator transfers and laminates modules automatically,improve the working efficiency2 Better temperature uniformity:±1°C,the temperature of multi-dot control fulfills a solidification craft demand absolutely3 Heating mode; adopt heat conduction oil of No.SD340,PID controlling system,with high precision4 Working Performance: it can operate 24 hours continuously in high temperature,which is applicable in industry and laboratory environment5 Proof-drape design of rubber:the design can lengthen available service life of rubber,improve laminating smoothness6 Structure characteristic: It pulls towards the back, which is convenient to module up and down.The plat of laminator is higher than the frame.Silica gel seal places on,which is lengthened the service life.It adopts patent techniques of laminated platform and integration of under-vacuum chamber ,which contribute to smoothness and non-deformation.7 Emergency openings system: It continues to laminate modules as emergency occurs(e.g. Power cut).Operator opens the upper cover and takes out modules by manual mode.8 Alarm system: when oil temperature of laminator can't reach the alarm limit, the system alarm automatically so as to warn the operators to take measures9 Ensure security-lock of upper cover: The upper cover can lock arbitrarily position and doesn't fall down when it works in usual.The upper cover locks any position automated when power cut urgently,so it can ensure operators safe10 Emergency system: Emergency pushbutton,operator may deal quickly and shut off total power supply as emergency11 Operation monitoring: It monitor the running parameters anytime by the operate interface (include degree of vacuum,temperature,pressure of air supply,running state and so on)12 Suitable range: it can laminate and cure, high compatibility of the production module ,apply to the lamination of the module of Single crystal silicon,polycrystal silicon,noncrystalline silicon. Main technical parameters: 1.Control characteristic: including automated mode and manual mode ,flexible control mode integrates with techniques of vacuum,laminating,PID temperature control,program control and relay output,which realizes various complicated control technology and laminates solar modules of single-crystal and multi-crystal silicon2.Control system :simenses control system, touch -screen control system3.Heating mode : adopts cycle heat oil4.Mode of temperature control: muilti-point control temperature,PID system5.working temperature range: room temperature --180°C6.laminating time: 2 4min7.evacuation time:5 8min8.work vacuum: 100 15Pa9.top cover stroke: 300mm10.operating environmental: can work in industry and laboratory environmentMain configuration1.temperature controller: RHK2.controller:Siemens3.exchange contactor:Schneider4.solenoid valve:SMC5.cylinder stator:6.module:Simense7.photoelectricity switch:SKY-e8.vacuum pump:9.heat oil pump:10.lamination slab rubber:11.vacuum survey: thermocouple gauge